ethtool -i enp2s0f0
driver: ixgbe
version: 5.1.0-k
firmware-version: 0x80000f32, 19.5.12
expansion-rom-version:
bus-info: 0000:02:00.0
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: yes
ethtool enp2s0f0
Settings for enp2s0f0: Supported ports: [ TP ] Supported link modes: 100baseT/Full 1000baseT/Full 10000baseT/Full Supported pause frame use: Symmetric Supports auto-negotiation: Yes Supported FEC modes: Not reported Advertised link modes: 100baseT/Full 1000baseT/Full 10000baseT/Full Advertised pause frame use: Symmetric Advertised auto-negotiation: Yes Advertised FEC modes: Not reported Speed: 10000Mb/s Duplex: Full Port: Twisted Pair PHYAD: 0 Transceiver: internal Auto-negotiation: on MDI-X: Unknown Supports Wake-on: d Wake-on: d Current message level: 0x00000007 (7) drv probe link Link detected: yes
ifconfig
enp2s0f0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 inet 192.168.1.7 netmask 255.255.255.0 broadcast 192.168.1.255 inet6 2408:****:****:9b80:b696:91ff:fe6f:5a78 prefixlen 64 scopeid 0x0<global> inet6 fe80::b696:91ff:fe6f:5a78 prefixlen 64 scopeid 0x20<link> ether b4:96:91:6f:5a:78 txqueuelen 1000 (Ethernet) RX packets 42383 bytes 5799527 (5.5 MiB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 14906 bytes 7721794 (7.3 MiB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
dmesg | grep ixgbe
[ 2.028447] ixgbe: Intel(R) 10 Gigabit PCI Express Network Driver - version 5.1.0-k
[ 2.028447] ixgbe: Copyright (c) 1999-2016 Intel Corporation.
[ 2.729215] ixgbe 0000:02:00.0: Multiqueue Enabled: Rx Queue count = 16, Tx Queue count = 16 XDP Queue count = 0
[ 2.830695] ixgbe 0000:02:00.0: 31.504 Gb/s available PCIe bandwidth (8 GT/s x4 link)
[ 2.943322] ixgbe 0000:02:00.0: MAC: 4, PHY: 0, PBA No: J69754-003
[ 2.943326] ixgbe 0000:02:00.0: b4:96:91:6f:5a:78
[ 3.106565] ixgbe 0000:02:00.0: Intel(R) 10 Gigabit Network Connection
[ 3.106594] libphy: ixgbe-mdio: probed
[ 3.808299] ixgbe 0000:02:00.1: Multiqueue Enabled: Rx Queue count = 16, Tx Queue count = 16 XDP Queue count = 0
[ 3.910503] ixgbe 0000:02:00.1: 31.504 Gb/s available PCIe bandwidth (8 GT/s x4 link)
[ 4.026732] ixgbe 0000:02:00.1: MAC: 4, PHY: 0, PBA No: J69754-003
[ 4.026733] ixgbe 0000:02:00.1: b4:96:91:6f:5a:7a
[ 4.188871] ixgbe 0000:02:00.1: Intel(R) 10 Gigabit Network Connection
[ 4.188899] libphy: ixgbe-mdio: probed
[ 4.189542] ixgbe 0000:02:00.1 enp2s0f1: renamed from eth1
[ 4.214902] ixgbe 0000:02:00.0 enp2s0f0: renamed from eth0
[ 5.897838] ixgbe 0000:02:00.1: registered PHC device on enp2s0f1
[ 6.117558] ixgbe 0000:02:00.0: registered PHC device on enp2s0f0
[ 11.258783] ixgbe 0000:02:00.1 enp2s0f1: NIC Link is Up 10 Gbps, Flow Control: RX/TX
[ 11.543897] ixgbe 0000:02:00.0 enp2s0f0: NIC Link is Up 10 Gbps, Flow Control: RX/TX
[ 11.738770] ixgbe 0000:02:00.0 enp2s0f0: NIC Link is Down
[ 12.166518] ixgbe 0000:02:00.1 enp2s0f1: NIC Link is Down
[ 12.454863] ixgbe 0000:02:00.0 enp2s0f0: NIC Link is Up 10 Gbps, Flow Control: RX/TX
[ 12.478795] ixgbe 0000:02:00.1 enp2s0f1: NIC Link is Up 10 Gbps, Flow Control: RX/TX
[12563.001690] ixgbe 0000:02:00.0 enp2s0f0: NIC Link is Up 10 Gbps, Flow Control: RX/TX